一、濟南鋁板http://www.www.yun-zhifu.com/模具上機前工作帶必須經過研磨拋光，工作帶一般要求拋光至鏡面，對模具工作帶的平面度和垂直度裝配前要進行檢查，氮化質量的好壞一定程度上決定了工作帶拋光的光潔度。
Jinan aluminum mold machine before working with polishing must work with the general requirements polished to a mirror finish on the front plane and perpendicular to the mold assembly work to be checked with the quality of the nitrided to some extent determine the quality of the work zone polished finish.

二、濟南鋁板擠壓生產時模具保溫時間一般在2-3小時左右，但不能超過8小時，否則模具工作帶氮化層硬度會降低而導致上機時不耐磨引起型材表面粗糙，壓型鋁板嚴重的會引起劃線等缺陷。
Jinan aluminum extrusion production molds holding time is generally about 2-3 hours, but not more than eight hours, otherwise mold work with the nitride layer hardness decreases caused when the machine does not cause wear and surface roughness profiles, pressure-type aluminum serious will cause defects such as crossed.

三、濟南鋁板采用正確的堿洗方法，模具卸模后供應充足，此時模具溫度在500°C以上壓型鋁板，如果立即浸入堿水中，由于堿水溫度要比模具溫度低得多，如果模具溫度下降迅速穩中下跌，模具極易發生開裂現象。正確方法是等卸模后將模具在空氣中放置到100°-150°C再浸入堿水中。
Jinan caustic aluminum with the right methods, adequate supply mold after mold unloading, when the mold temperature at 500 ° C over-pressure aluminum, if immediately immersed in alkaline water,alkaline water temperature due to the mold temperature is much lower than that, if the mold temperature decreased rapidly steady decline, prone to cracking phenomenon mold. The correct way is to remove the mold after mold, etc. placed in the air to 100 ° -150 ° C and then immersed in alkaline water.

四、濟南鋁板http://www.www.yun-zhifu.com/建議優化擠壓工藝，要科學延長模具壽命，合理使用模具進行生產是不容忽視的一個方面，由于擠壓模具的工作條件極為惡劣，在擠壓生產中一定要采取合理的措施來確保模具的組織性能。
Jinan aluminum extrusion process optimization proposal to extend die life science, rational use of mold production is one aspect can not be ignored, because the extrusion die extremely harsh working conditions in the extrusion production must take reasonable steps to ensure that mold organizational performance.